24Port Gigabit Active PoE Midspan Injectors Switch for 802.3af/at devices like Voip phones WiFi AP's supports POE, VLAN, 1G switching

24Port Gigabit Active PoE Midspan Injectors Switch for 802.3af/at devices like Voip phones WiFi AP's, supports POE, VLAN, 1G switching

SPECIFICATIONS

High-concerned Chemical: None

Type: Other

Model Number: GAT-24

Private Mold: Yes

Products Status: Stock

Ports: 24

Transmission Rate: 10/100/1000Mbps

Function: POE, VLAN Support

Communication Mode: Full-Duplex & Half-Duplex

Switch Capacity: 1G

Product Description

24 Port Active 802.3at PoE Injector for High Powered Devices like Cisco WiFi APs, PTZ Cameras and more

Gigabit/Active, Mode A, rack mount 24 Port Injector without a power supply

Add 802.3at power to any switch: Save big on network upgrades by using this injector to add

802.3at Power over Ethernet without upgrading to a more expensive network switch.   

Power IP cameras, desktop phones, WiFi access points, and more:   This 802.3af/at compliant

Power over Ethernet (PoE) injector takes power from the included 48 volt DC power supply and adds it to an

Ethernet data cable (Cat5, Cat5e, Cat6) to power your PoE devices.

Active PoE means the right power at the right time:   An active PoE injector negotiates with the

powered device to deliver the power as needed, so there are no concerns about accidentally

burning out lower powered or non-PoE devices. Power is only added to the data cable when an

802.3af or 802.3at device is connected.

FEATURES

24 Port 802.3af / at compliant Gigabit Ethernet Injector

– 24 Shielded RJ-45 LAN

– 24 Shielded RJ-45 LAN+POE

– PoE status LED for each jack

– All 4 data pairs active for gigabit data rates

– shared data and power via transformer power injection on 12 – and 36+

– pins 45 78 pass thru without modification

Specifications:

1U high standard rack mount ( 1.75 x 19 x 2 inches)

· 315 current limiter per port per 802.3af specifications

· 650 ma current limiter per port per 802.3at specifications with a 802.3at load

· No power is supplied to non-PoE devices

· Same voltage to all ports

· Dual power supply inputs with relay failover/ load balancing.

· LEDs for input power display – one per input

Green – 48 volts, Amber – 56 volts

· 24 LEDs for per port PoE mode display. Blue if a PoE device is connected

· Use with any Ethernet switch – passes all management info transparently

· Ideal for IP Cameras, VOIP phone, WiFi Access Points with 802.3af or 802.3at

· Technical support world wide

· Power supply range 48 to 56 volts via 2.1mm x 5.5mm input ( 2 )

· Additional Phoenix DC connector

  3.5mm model 1844236 - pin 1,2 (minus) 3 (plus)

Environmental

– operating temperature range – 0 to 50 deg C

– storage temperature range – 0 to 50 deg C

– relative humidity range – 5 to 90% non condensing

– FCC rules – there are no RF emitting devices in the design

– the device is PELV per NFPA standard 79 – protected extra low voltage

– no cooling is required, no fans. Quiet operation with no moving parts

Technical Specifications: